Rigid type. Fits every Burman gearbox 1938 onwards (and probably a lot of earlier ones too). Can also be used as a gear lever on some bikes. Diameter between splines16,9 mm.
Chrome plated; excellent quality. (These do NOT bend on the second kick) Rubber and chrome plated bolt included.
Ariel, AJS, Matchless, Panther, Vincent Comet/

Can be folded away if need be. Chrome plated.

This replaces the early cast in bearing type. 1938-1956 500 and 650cc twins. As shells you can use those for the 3TA/5TA  part number 70-3706

Fit it to the camshaft or crank, put the piston in top dead centre, mark this point with a felt tip or a wire, put the bike  in gear, turn the rear wheel backwards, then forwards and you'll notice the position of the crank on this gorgeous plastic dial!
If fitted to the camshaft divide by 2.

Single phase stator 2 wire 12V 11A, RM21.
6 COILS
BRITISH MADE

Brass levers in prewar BSA style.
Diameter 7/8"

Keeps the clutch and brake cables nicely tied to the handelbars. Chrome plated. Fits all 7/8 handlebars.